User manual

Phantom Camera Control Application - Help 129
© 2010 Vision Research - An AMETEK Company
Spark Crank Angle (deg)
Reset Angle (deg)
Cyl. Pressure (bar)
Text
NOTE
All the optional lines, if selected, will be displayed above the cine.
b)
Inside Image:
time stamp - Where each image is tagged with the absolute date and time the image was
recorded. Enabling this option will display the time stamp information when the file is
played back.
From Trigger - When this option is selected the exact time the image was recorded from
the time the trigger input was detected will be displayed.
Draw Signals - When available the user can define which analog signal sample
information will be displayed in the corners of each image, up to four signals, (only
available if the cine file was captured using an attached Data Acquisition Unit and SAM-3
for signal Acquisitions).
Samples per Stamp - Used to display the acquired selected signal samples on each
image . The Samples per Stamp value is the number of samples to be displayed in the
small corner windows representing the acquired signal. Its minimum value should be the
value of "Samples per image" defined in Live Panel>Advanced Settings>Signals.
NOTE
The information displayed inside the image cannot be removed.
h.
Specify the Lossy Compression Quality. (This option is only available when saving as a Cine
JPEG, LEAD, LEAD JFIF, LEAD JTIF, JPEG, or JTIF file type.)
i.
Click the Save button to save the cine file.
9.
In the AVI Option dialogue window:
a.
Enter the desired playback Frame Rate in the Frame Rate (fps) entry field.
b.
Click the down-arrow next to the right of the Video Compressor field, then
c.
Select the desired video compressor.
d.
Adjust the Compression Quality to the required setting, if available.
e.
Click the OK button.
RESULT: The Preview Panel displays a Saving Cine.. message , and the Preview Panel Status
Bar displays a Saving.. progress indicator. The files will be saved with the following name
convention: <root_filename>_<camera_name><camera_model><camera_serial_number><Cine#.
ext>.
The system also creates a .chd file for each cine file saved. The .chd file is the cine header file
containing information about the cine file that can be used in the event you wish to convert the file
back to a cine file at a later date.