User manual

Phantom Help File100

Sensitivity

The Sensitivity parameter defines the:

Threshold

The Threshold specifies the amount a pixel value must change in order to be counted

as an active pixel for auto-trigger purposes. A value of 100 would require a change of

approximately half of the full swing of the camera. A typical threshold setting would be

10.

Area %

The Area % specifies the percentage of the auto-trigger region that must be active in

order for an auto-trigger event to be generated. A typical percentage value is 10.

Check Interval (ms)

The Check Interval parameter specifies the speed between updates the auto-trigger

region is checked.

Area

Area defines the auto-trigger region, and is defined by entering the following

parameters:

Top

Specifies the y-coordinate of the top row of pixels.

Left

Specifies the x-coordinates of the left column pixels.

Right

Specifies the x-coordinates of the right column pixels.

Bottom

Specifies the y-coordinate of the bottom row of pixels.

Show On Image Enable Box

When enabled, (checked), a yellow dotted box, indicating the auto-trigger region,

where image changes are analyzed, will be displayed over the area specified by

the end-use in the Preview Panel, and will not be recorded with the image data.

Full Button

When enabled, (checked), instructs the software to analyze the entire image area.

Continuous Recording Selector

Continuous Recording is a functionality to continuously record in camera RAM and auto-save

stored cines. If the camera is in MultiCine mode the camera will record sequentially in cine slots.

When the RAM is full the needed cine RAM slot will only be deleted and captured if it was saved,

otherwise there will be a wait until this action completes.

NOTE

Only one save at a time will be done from one camera.