User manual

PHANTOM 2 VISION Product Release Notes
© 2013-2015 DJI. All Rights Reserved. 1
Firmware Updates on April 27, 2015
Overview：
a) Flight controller firmware has been updated to v3.14.
Major New Features
No-Fly Zones have been updated to include a 1.2 km radius centered on the Imperial Palace and a 1 km
radius centered on the Prime Minister's Official Residence, both in Tokyo, Japan.
Firmware Updates on March 03, 2015
Overview：
b) Flight controller firmware has been updated to v3.12.
Major New Features
a) No-Fly Zones have been updated to include a 25km radius centered in Washington, DC.
b) The compass calibration program has been optimized to improve reliability.
c) When automatic landing is initiated, users can now continue to control the aircraft’s position and
altitude. During this process, the maximum speed of ascent is 1 m/s.
d) After an automatic landing has been completed and the motors have stopped spinning, users can
immediately restart the motors and begin a new flight.
Special Note:
a) It is recommended that the compass be calibrated in an environment that is free from sources of
potential interference. If you become aware of any source of potential interference, move to a
different location and calibrate the compass again. Be aware that underground metal pipes may cause
interference when the aircraft is close to the ground during compass calibration.
VISION App Updates on February 13, 2015
Overview：
a) DJI VISION App has been updated to iOS v1.0.48, Android v1.0.58.
Major New Features
a) An issue that caused The VISION app to crash on Android 5.0.1 devices has been fixed.
b) Bugs that were discovered in the VISION app have been removed.