User's Manual

configuration setting, refer Table 1 (Parameter 1) will send Basic Set OFF (0x00), Red

LED will flash once, and refer to table for status.

4. The ZP3112 sensor equipped with tamper switch. If the tamper switch is triggered (or

remove the cover), the ZP3112 sensor will send Alarm Report, LED will flash once and

refer to table for status.

5. If the tamper switch is closed (or closed the cover), ZP3112 will send Alarm Report,

and refer to table for status.

Alarm V1

(Movement & Tamper

Switch)

Notification V4

(Movement)

Notification V4

(Tamper Switch)

Alarm Type 0x07

Alarm Level

0x00 (No movement

after 3 mins)

0xFF (Motion

detected)

Notification Type 0x07 0x07

Notification

Event

0x08(Motion

Detected)/

0x00 (no movement

after 3 mins)

0x03(remove cover)/

0x00 (cover closed)

Notification

Event Parameter

0x08

0x03

Support OTA Firmware update from controller. Please refer to your controller manual

and use COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2. To proceed the OTA

process.

- 5 -