User's Manual

ManualsBrandsVision Automobile Electronics Industrial ManualsElectronicsWireless 4 IN 1 Multi-Sensor

Installation & Operation Manual

ZD2201IN-5

ZD2201MY-5

ZD2201EU-5

ZD2201RU-5

ZD2201US-5

ZD2201IL-5

ZD2201KR-5

ZD2201HK-5

ZD2201JP-5

ZD2201BR-5

Wireless 4 IN 1 Multi-Sensor

(Dry Contact, Humidity, Temperature & Light)

ZD 2201

1050225

6B1Z-22001

Summary of content (4 pages)

PAGE 1
Installation & Operation Manual ZD2201IN-5 ZD2201MY-5 ZD2201EU-5 ZD2201RU-5 ZD2201US-5 ZD2201IL-5 ZD2201KR-5 ZD2201HK-5 ZD2201JP-5 ZD2201BR-5 Wireless 4 IN 1 Multi-Sensor (Dry Contact, Humidity, Temperature & Light) ZD 2201 V0 1050225 6B1Z-22001
PAGE 2
Introduction Thanks for choosing the Vision’s wireless 4 in 1 Multi-Sensor (door window contact sensor, humidity sensor, temperature sensor, and light sensor) of the home security device. This sensor is a Z-Wave™ enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave™ enabled network and its security framework.
PAGE 3
Configuration – Humidity Parameter Number Size VALUE Preset 3 1 1~50 (Set up from 1%~50%) 10% Configuration – Light Parameter Number 4 Size VALUE Preset 1 0,5~50 (Set up from 0 for Off or 5%~50%) 10% Installation Notice: If you are installing the entire Z-Wave™ system for the first time, please refer to the installation guide of Z-Wave™ Interface Controller before installing ZD2201. 1. Push release button to open the rear cover. 2.
PAGE 4
Use adhesive tape for sensor 6. Sensor Type 0x05 Scale 0x00 (%) Size and Precision 2 Light Report- If the present illumination is different with the sensor record and exceed the setting program, the sensor will report the present illumination. Multilevel Sensor Report Operation 1. 2. 3. 4. Opening/Closing the door/window to separate the magnet from the sensor will send signal to any association nodes according to the Status/Signal table on page 2 and the LED will flash once.