User's Manual

Door/Window Contact
Introduction
This is a supervised, wireless, door/window contact intender for use with certain 345Mhz
Alarm systems. Please has qualified service persons install this device for you.
Product Description and Specification
*** For indoor use only ***
Specification: Package Content:
Frequency Range: 345MHz +/- 150KHz
Operating Range: Up to 100 feet line of sight
Dimensions: 74x42x28 mm
Operating Temp.: -15°C~ 60°C (5°F~140°F)
Battery: Panasonic CR123A * 1PC
1pc
1pc
1pc
1pc
3pc
1pc
Door/Window sensor
Magnet set
Bracket Holder
Adhesive tape for sensor
Screw
CR123A Lithium Battery
Installation
Notice: Select a mounting location free from exposure to moisture and humidify.
1. Install Battery: Use care when installing the battery. Press the locking tab on the top
sensor cover, and then gently pull up the cover. Observe the correct polarity before
insert the battery.
2. If a wired contact loop is to be used with concealed wiring, feed the wires through
the concealed wiring entry hole. A thin breakout area I provided on the side of
case. Wiring can be run through the breakout in the case.
3. Using the adhesive tape or fixing screws to fix the bracket holder with sensor.
4. Find the notch on the outside of the door/window enclosure. Align the magnet with
the notches that the distance between magnet & transmitter can’t exceed 3/4”.
Mount the magnet by supplied adhesive tape.
Federal Communications Commision Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio
communications. Howeve, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try and correct the interferene by one of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver,
- Connect the equipment into and outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undersired
operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
Limited Warranty
We Guarantees that every wireless Door/Window sensor is free form physical defects in
material and workmanship under normal use for one year from the date of purchase. If
the product proves defective during this one-year warranty period, we will replace it free
of charge. We does not issue any refunds. This warannty is extended to the original end
user purchase only and is not transferable. This warranty does not apply to : (1) damage
to units caused by accident, dropping or abuse in handling, or any negligent use; (2)
units which have been subject to unauthorized repair, opened, taken apart, or otherwise
modified; (3) units not used in accordance with instruction; (4) damanges exceeding the
cost of the product; (5) transit damage, initial installation costs, removal cost, or
reinstallation cost. Please contact local dealer for more information.
※ T his device does not exist and support the polling function.