Datasheet

TMCJ
www.vishay.com
Vishay Polytech
Revision: 16-Jan-17
4
Document Number: 40176
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
Note
• Test conditions per JIS C5101-1
STANDARD PACKAGING QUANTITY
CASE CODE UNITS PER 7" REEL
J 4000
PERFORMANCE CHARACTERISTICS
ITEM CONDITION POST TEST PERFORMANCE
Temperature
characteristics
Measure the specified
characteristics in each stage
Specified
initial value
-55 °C +85 °C +125 °C
Capacitance change - -20 % to 0 % 0 % to +20 % 0 % to +20 %
Dissipation factor
(%) max.
20 30 20 30
Leakage current
Refer to
Standard
Ratings
table
-
1000 %
specified
initial value
or less
1250 %
specified
initial value
or less
Solder heat
resistance
Solder dip:
260 °C ± 5 °C, 10 s ± 1 s
Reflow
260 °C, 10 s ± 1 s
Capacitance change Within ± 20 % of initial value
Dissipation factor Initial specified value or less
Leakage current Initial specified value or less
Moisture
resistance
no load
Leave at 40 °C and 90 % to 
95 % RH for 500 h
Capacitance change Within ± 20 % of initial value
Dissipation factor Shall not exceed 150 % of initial specified value
Leakage current Initial specified value or less
High
temperature
load
85 °C. The rated voltage is
applied for 2000 h
Capacitance change Within ± 20 % of initial value
Dissipation factor Initial specified value or less
Leakage current Shall not exceed 200 % of initial specified value
Thermal shock
Leave at -55 °C, normal
temperature, 125 °C, and
normal temperature for 30 min,
3 min, 30 min, and 3 min.
Repeat this operation 5 times
running
Capacitance change Within ± 20 % of initial value
Dissipation factor Initial specified value or less
Leakage current Initial specified value or less
Failure rate
85 °C. The rated voltage is
applied through a protective
resistor of 1 /V
1 %/1000 h