User`s guide

Now we have completed constructing the VI. If there is any error in the program, the run

button will appear “broken” as shown in the figure below. Click on the button to view the error

list, the “details” should explain the error. Debug until all errors are resolved; use other

debugging functions on the menu bar if needed.

When the run button appears as a rightward arrow, enter appropriate parameters on the

Front Panel, connect a BNC cable to AI0 of the DAQ device with two idle clips (this will

provide some varied voltage inputs), and test run the program. Use Edit



Make current values

default to save the entered parameters as default values. If there is no error interrupting the run,

we can check the data file under the specified directory for satisfactory results. Trouble shoots

until the program is ready for use.

Now the VI is ready for the Soda Can Laboratory. Can you make it better?