User`s guide

21
Figure 5 Connections for Honeywell UV-10 In-line Amplifier
2. Gain setting
While excitation jumper is set to 5V, in order to get a gain of 200, make sure switch 3
and switch 6 are on and other switches are off.
3. Calibration
With zero loads on the strain gauge, adjust the ZERO potentiometers until the reading
approaches 0.
It is required to open the enclosure to adjust both the ZERO potentiometers and the gain.
The wire connections are located inside the enclosure as well.
4.1.3.3 Set-up Procedure for Omega DMD-465 WB
1. Connections
Connect the wires as indicated in Figure 6.