User`s guide

20
Figure 4 Location of Gain select switch and offset potentiometer
G0
G1
G2
ON
OFF
OFF
Table 7 Switch settings for Tacuna for 220 Gain
3. Bridge Balance
Use the offset potentiometer to adjust the output voltage to 2.5V, which is half of the
output range.
It is required to open the enclosure to adjust the gain switches but not the offset
potentiometer. The wire connections are located outside of the enclosure.
4.1.3.2 Set-up Procedure for Honeywell UV-10
1. Connection
Connect the wires as indicated in Figure 5.