User`s manual

15. PEDAL SETTINGS
The pedals on the BURN can be configured to take different behaviors depending on the user's needs. With the exception
of BYPASS pedal, which will always be used to enable or disable the Stereo True Bypass, the STOP and SPEED pedals can
also perform other functions.
15.1. BYPASS PEDAL
When the True Stereo Bypass is activated, the incoming audio signal found at the input Left and Right jacks is directly led
to the output jacks with no change. This type of bypass is known as "true" because it bypasses the entire electronic
circuit by means of a mechanical contact. When the unit is turned off, the bypass is always active because the relay that
takes care of its operation is in a resting state.
The bypass status will always be saved in presets along with all the other parameters, but you can choose whether this
must be recalled when a preset changes or must remain completely independent. To operate this choice, go to the page
[PEDAL] BYPASS.
[PEDAL] BYPASS
Global Setting
15.2. STOP PEDAL
When a Rotary effect is in use, the STOP pedal stops the rotation of the virtual rotors exactly like a real rotating speaker
would do with this function. However, if you do not want to use the stop position, you can choose to use this pedal to
activate or deactivate the tube distortion. To make that choice go to the page [PEDAL] STOP. When the STOP pedal is
assigned to Overdrive Switch, you can hold down the SPEED pedal for about one second to engage the STOP speed.
[PEDAL] STOP
Overdrive Switch
15.3. SPEED PEDAL
When a Rotary effect is in use, the SPEED pedal is used to switch the speed of the virtual rotors between slow and fast.
The selected speed is always saved in the presets along with all the other parameters. Like the Bypass function, you can
choose whether this is to be recalled from the presets or must remain a totally independent function. To make such a
choice, go to the page [PEDAL] SPEED.
[PEDAL] SPEED
Saved in presets
Each pedal has an LED that is switched on or off to indicate its status. The operation of the SPEED pedal LED can be
chosen at the next page, and can be of three types:
– FAST On/Off: the LED is lit when the speed is FAST, off when the speed is SLOW
– Anim & Stop: the LED flashes quickly or slowly depending on the speed, and stops when the speed is STOP
– Anim always: the LED flashes quickly or slowly depending on the speed and continues to flash even though the
speed is STOP
By default, the LED is set to On/Off.
15.4. PRESET UP & DOWN
When an optional accessory is connected to the REMOTE jack and the EXTERNAL function is activated, pedals STOP and
SPEED function as PRESET PRESET UP and DOWN to decrease or increase the number of current preset.
GSi BURN USER'S MANUAL - Pag. 13/16