User`s manual

12. MIDI SETTINGS
The BURN allows a detailed and customizable MIDI control in order to meet multiple needs. It is possible to control all
real-time parameters via MIDI, it's possible to recall presets and, most importantly, it's possible to control the Rotary
speeds via MIDI commands.
The first page of the MIDI settings allows to set the receive MIDI Channel. The range is 1 to 16 or OMNI, that means
that incoming events won't take the channel into consideration. Default setting is channel 1.
[MIDI] CHANNEL
888888888888Omni
To control the Rotary speeds it's possible to choose between one of the pre-set control sets or to create a custom control
set. Go to the page [MIDI] SPEED CTR to choose a Speed Control set.
[MIDI] SPEED CTR
GENERIC CC # 1
The following table gives details about the factory pre-set control sets.
GENERIC CC # 1 Uses CC#1 (Mod.Wheel) for 0-32 = SLOW; 33-95 = STOP; 96-127 = FAST
CRUMAR MOJO Compatible with the commands of organs Crumar MOJO and Hamichord
NORD ELECTRO 3/4 Compatible with the commands of the keyboards Nord Electro 3 and 4
NORD C1/C2 Compatible with the commands of organs Nord C1, C2 and C2d
NORD STAGE 2 Compatible with the commands of the Nord Stage 2
KORG CX3/BX3 Compatible with the commands of organs Korg series CX3 and BX3
NUMA ORGAN/KeyB Compatible with the commands of organs Studiologic Numa Organ and DLQ KeyB Duo/Solo
VISCOUNT DB5/DB3 Compatible with the commands of organs Viscount/Oberheim DB5 and DB3
HAMMOND SK1/SK2 Compatible with the commands of organs Hammond-Suzuki series SK1 and SK2
HAMMOND XK3/XK3c Compatible with the commands of organs Hammond-Suzuki series XK3 and XK3c
KRONOS CC#80/81 Compatibile with the side keys of the Korg Kronos
PITCH/CC#1 JS Uses the pitch bender for SLOW/FAST and the Mod. Wheel for RUN/STOP
USER DEFINED Uses custom messages (explained later in this manual)
When the control set is USER DEFINED, it's possible to decide whether the commands must be of type "Latched" or
"Temporary". This same setting is applied to the optional accessory connected to the REMOTE jack.
[MIDI] SPEED TYP
Latched
Once the Control Change numbers have been assigned to the controls SLOW/FAST and STOP/RUN, it's necessary to
verify with the sender device whether the values of the Control Change are kept (latched) or reset (temporary). For
example, if the external controller uses a push button to switch between SLOW and FAST, the unit could manage the
MIDI messages in two ways:
– Temporary mode: button pushed = value 127; button released = value 0
– Latched mode: every time the button is pushed the value alternates between 0 and 127
According to the criteria used by the external MIDI unit, it's necessary to set this parameter the other way around,
because if, for example, the external controller uses Temporary controls, the BURN will have to latch them.
GSi BURN USER'S MANUAL - Pag. 11/16