User`s manual

10. RENAME, SAVE OR INITIALIZE A PRESET
Each preset can have an alphanumeric name up to a maximum of 12 characters. To assign a name to a preset, go to the
[PRESET] NAME page. Press EDIT/ENTER to show the cursor, turn the encoder to position the cursor underneath a
character to be changed. Press EDIT/ENTER to change the character. The cursor flashes. Turn the encoder to select the
character. To delete a character, turn the encoder clockwise until the character disappears (or appears a space).
[PRESET] NAME
01: GSi BURN_
Next page allows to save the preset to one of the 32 available memory locations.
[PRESET] WRITE
To position...12
Press the EDIT/ENTER button and turn the encoder to select the memory location. Press EDIT/ENTER again to to save.
It's possible to initialize the current preset with the default settings. Move to the [PRESET] INIT page and confirm by
pressing the EDIT/ENTER. Caution: This operation will overwrite the current preset and can not be undone.
[PRESET] INIT
Are you sure?
11. INPUT/OUTPUT FUNCTIONS
[I/O] RIGHT IN
PASS THRU
[I/O] OUT BOOST
100%
The audio input used to bring the signal to the DSP processor is LEFT/MONO, while the RIGHT input remains free in case
you want to connect an instrument with stereo output and take advantage of both channels when you are in BYPASS
mode, or you might want to use the RIGHT input for connecting an audio source to listen DRY in addition to the signal
from the BURN. In this case, set the parameter [I /O] RIGHT IN to PASS THRU.
In the example shown here, a Crumar Mojo is connected to the
LEFT/MONO input of the BURN in order to to use the Rotary
effect on the sound of the organ, and an mp3 music player or
any smartphone can be connected to the RIGHT input. By
activating the I/O RIGHT INPUT PASS THRU, the audio coming
from the mp3 player is mixed with the organ sound. By
connecting a good stereo headphone directly to the BURN you
can practice playing along with a backing track without
disturbing the neighborhood.
In case the input signal level is too weak or it is too hot to overload the DSP and needs to be reduced, it is possible to
compensate the difference between the input and the output level by adjusting the value of the page [I/O] OUT BOOST
up to a maximum of 195%, which corresponds to nearly +3 dB (loudness almost doubled). This function works only
when the page [I/O] RIGHT IN is set on OFF.
GSi BURN USER'S MANUAL - Pag. 10/16