User Manual
Table Of Contents
- ITALIANO
- INDICE
- 1. NOTE IMPORTANTI
- 1.1 CURA DEL PRODOTTO
- 1.2 NOTE RIGUARDANTI IL MANUALE
- 2. INTRODUZIONE
- 2.1 CARATTERISTICHE GENERALI DI LEGEND E LEGEND LIVE
- 3. COMANDI E CONNESSIONI
- 3.1 PANNELLO SUPERIORE
- 3.2 PANNELLI LATERALI
- 3.3 PANNELLO POSTERIORE
- 4. ACCENSIONE E NORMALE FUNZIONAMENTO
- 4.1 COSA SONO E COME SI UTILIZZANO I DRAWBARS
- 4.2 COSA SONO E COME SI UTILIZZANO I PRESETS
- 4.3 LA PERCUSSIONE
- 4.4 AGGIUNGERE I RUMORI INTERNI
- 5. AGGIUNGERE GLI EFFETTI AL SUONO
- 5.1 VIBRATO O CHORUS
- 5.2 REVERB
- 5.3 DRIVE
- 5.4 ROTARY
- 6. FUNZIONI AGGIUNTIVE
- 6.1 TRASPOSIZIONE
- 6.2 GOSPEL SET
- 6.3 FUNZIONE PANIC
- 6.4 FUNZIONE MIDI DUMP
- 7. APPENDICE
- 7.1 PRESET DI FABBRICA
- 7.2 MAPPA DELLE FUNZIONI RICHIAMABILI CON IL MANUALE SUPERIORE
- 7.3 RISOLUZIONE AI PROBLEMI PIU’ COMUNI
- ENGLISH
- INDEX
- 1. IMPORTANT NOTES
- 1.1 PRODUCT CARE
- 1.2 NOTES ABOUT THIS MANUAL
- 2. INTRODUCTION
- 2.1 GENERAL FEATURES OF LEGEND AND LEGEND LIVE
- 3. CONTROLS AND CONNECTIONS
- 3.1 UPPER PANEL
- 3.2 SIDE PANELS
- 3.3 REAR PANEL
- 4. SWITCHING ON AND NORMAL FUNCTIONING
- 4.1 WHAT ARE DRAWBARS AND HOW TO USE THEM
- 4.2 WHAT ARE PRESETS AND HOW TO USE THEM
- 4.3 PERCUSSION
- 4.4 INTERNAL NOISES SIMULATION
- 5. USING EFFECTS
- 5.1 VIBRATO OR CHORUS
- 5.2 REVERB
- 5.3 DRIVE
- 5.4 ROTARY
- 6. ADDITIONAL FUNCTIONS
- 6.1 TRANSPOSITION
- 6.2 GOSPEL SET
- 6.3 PANIC FUNCTION
- 6.4 MIDI DUMP FUNCTION
- 7. APPENDIX
- 7.1 FACTORY PRESETS
- 7.2 MAP OF THE FUNCTIONS RECALLED THROUGH THE UPPER MANUAL
- 7.3 TROUBLESHOOTING
- DEUTSCH
- INHALT
- 1. WICHTIGE HINWEISE
- 1.1 PFLEGE DES INSTRUMENTS
- 1.2 HINWEISE ZU DIESEM HANDBUCH
- 2. EINLEITUNG
- 2.1 AUSSTATTUNGSMERKMALE DER LEGEND UND LEGEND LIVE
- 3. REGLER UND ANSCHLÜSSE
- 3.1 OBERES BEDIENFELD
- 3.2 SEITLICHE BEDIENFELDER
- 3.3 RÜCKSEITE
- 4. EINSCHALTEN UND NORMALBETRIEB
- 4.1 ÜBER ZUGRIEGEL UND IHRE ANWENDUNG
- 4.2 ÜBER PRESETS UND IHRE ANWENDUNG
- 4.3 PERCUSSION
- 4.4 INTERNE GERÄUSCHSIMULATION
- 5. EFFEKTE ANWENDEN
- 5.1 VIBRATO ODER CHORUS
- 5.2 REVERB
- 5.3 DRIVE
- 5.4 ROTARY
- 6. WEITERE FUNKTIONEN
- 6.1 TRANSPOSITION
- 6.2 GOSPEL-SET
- 6.3 PANIK-FUNKTION
- 6.4 MIDI DUMP-FUNKTION
- 7. ANHANG
- 7.1 WERKS-PRESETS
- 7.2 KARTE DER MIT DEM OBEREN MANUAL ABRUFBAREN FUNKTIONEN
- 7.3 FEHLERSUCHE
EN - 20
User Manual
viscount
connected to the [FX SEND] port.
The sound is distorted or you hear noise from the speakers.
- Decrease the volume.
- The distortion effect has been activated through the [DRIVE] potentiometer on the side panel of the upper
manual. If you do not want to apply a distortion, turn the potentiometer to the far left.
The reverb effect is not present in the [ROTARY SPEAKER] output.
- Set the PRE mode of the Reverb effect (see section 5.2).
The instrument is not in tune with the others.
- Adjust the pitch with the [TUNING] trimmer on the side panel of the upper manual.
The expression pedal has no effect.
- Verify that the pedal cable is correctly connected to the [EXP] connector on the rear panel and that it is not
damaged.
The switch pedal(s) have no effect.
- If you want to control Rotary speed check that the cable is properly connected to the [ROTARY] port.
- If you want to use the Hold function (Sustain) check that the pedal cable is connected to the [HOLD]
connector.
- Check if the connection cable is damaged.
The pedal(s) work in reverse.
- Make sure your pedal(s) belong to the Normally Open (N.O.) type.
One or more of the following controls / effects do not seem to work.
- Pedalboard: it is set in Direct mode (the led of the [PEDALS DIRECT] button in
Legend
or [PEDALS TO
LOWER] in the
Legend Live
turns red).
- Pedalboard: when playing with the lower manual, check that the [PEDALS TO LOWER] button led is on.
- Rotary: it is set in Direct mode ([ROTARY DIRECT] button led on
Legend
or [ROTARY CLASSIC/ROCK]
button led on
Legend Live
turns red).