User Manual

Table Of Contents

EN - 18

User Manual

viscount

6. ADDITIONAL FUNCTIONS

6.1 TRANSPOSITION

Both manuals and the pedalboard can be transposed within a range of -6 / +5 semitones.

To set the transposition, while holding the [TRANSPOSE SELECT] button, press one of the upper manual keys

from F#1 (-6 semitones) to F2 (+5 semitones). C2 corresponds to no transposition.

When the [TRANSPOSE SELECT] button's led is on, this means that the manuals and pedals are transposed.

6.2 GOSPEL SET

The Gospel musicians had a habit of playing exclusively with the lower manual. Therefore, to adjust the

drawbars of a classic electromechanical organ they had to cross their arms, since the lower manual drawbars

are on the right. To make access to drawbars faster and more convenient, drawbar circuits were inverted, so

that the lower manual drawbars were on the left.

Legend

Legend Live

allows you to simulate this organ setting. To activate the Gospel mode, press and hold

the [TRANSPOSE SELECT] button, then at the same time press the D1 key on the upper manual. Doing so, the

first two Sets on the left control the lower manual, while the two sets to the right control the upper manual.

To return to normal use, press and hold [TRANSPOSE SELECT], and simultaneously press the C1 key of the

upper manual.

6.3 PANIC FUNCTION

The Panic function allows you to instantly silence all the notes that are currently playing. This function is to be

used if, due to reasons unrelated to the instrument (mainly electrical disturbances or duplicated notes from

MIDI IN), it is no longer possible to turn off one or more notes. To recall this function, while pushing the

[TRANSPOSE SELECT] button, press the C6 key on the upper manual.

6.4 MIDI DUMP FUNCTION

If you need to register the current instrument configuration (drawbars, buttons, potentiometers and pedals) on

an external sequencer, after you start recording hold down the [TRANSPOSE SELECT] button and press the

C3 key on the upper manual. Use the same button and key combination if you want to reset the instrument with

the current panel configuration after receiving a different setting from the sequencer at playback time.

Transposition is also applied to the notes received through the [MIDI PEDALS KEYB ONLY] connector, but not to the

notes received through the [MIDI IN] connector.