User Manual

EN - 11
User Manual
viscount
( Legend model) or [ROTARY CLASSIC/ROCK] ( Legend Live) flashes, in order to indicate that the
selected speed does not correspond to that indicated by the current position of the instrument's control
lever (see point 21 of par. 3.2).
-
[HOLD]: plug here the cable from the switch pedal that you wish to use for the piano Sustain effect. This
way, when the pedal is pressed, the notes played on the upper manual keep playing even after the key
is released, and until the pedal is released. Use with:
 Control lever on the expression pedal of the optional Viscount pedal set (ROTARY cable).
 Optional Viscount switch pedal.
 Pedal switch of the normally open type (N.O.)
4.
[MIDI] connectors.
-
[IN]: connector for receiving data from an external MIID unit. Connect this port to the MIDI OUT port of a
transmitting device (e.g. a sequencer).
- [PEDALS KEYB ONLY]: connect here the optional Viscount pedalboard or any other MIDI pedalboard.
This pedalboard will play the instrument's pedalboard drawbars.
-
[THRU]: this port transmits the incoming data from the [IN] port to other MIDI devices (e.g. to play the
data transmitted by an external sequencer, through
Legend / Legend Live , with an external expander
module).
-
[OUT1] and [OUT2]: this connectors send out the MIDI data generated by Legend / Legend Live .
Connect this port to the MIDI input of the receiving device (e.g. an expander module).
The following table shows the MIDI channels assigned to the connectors described above:
Sect
ion
[IN]
[PEDALS KEYB ONLY]
[OUT1]
[OUT2]
Upper manual
1
---
1
4
Lower manual
2
---
2
5
Pedalboard
3
1
-
16
3
6
5.
[USB TO HOST] connector: USB socket sending and receiving MIDI data to and from external devices
(computers, expanders). Use this port to update the instrument's firmware.
6.
[USB CHARGER] connector: USB socket to power and/or charge the battery of a multimedia device such
as smartphones or tablets.
7. [MAINS AC-IN] connector: plug here the power cord supplied with the instrument.
8. [POWER] switch: on / off switch.
NB
Even though both the [IN] and [PEDALS KEYB ONLY] ports are MIDI inputs, it is strongly adviised to use the [PEDALS
KEYB ONLY] connector with MIDI pedalboards, since the port has been developed for this purpose. Furthermore,
notes received through this connector are recalculated according to the currently set transposition (if any) and then
sent to the [OUT 1] and [OUT 2] ports, so they can be played also through external devices.
NB
In some models, the fuse in the [MAINS AC-IN] socket is not present.