User manual

-22-
Problems listed below do not necessarily signify a fault with the unit.
Please check this list before requesting repairs.
Problems
13. Troubleshooting
No picture and no sound
Check the connection with the AC adaptor or car adaptor.
Use of an unauthorized power supply.
Press POWER on the remote to turn on the device, or press
and hold POWER on the device for 1.5 seconds to turn it on.
Check the channel selection. Scan for channels again.
Always rescan for channels in new locations.
Check the sound volume. If you are using earphones, test
them on another item. Check the earphone cable is plugged
into the earphone socket on the device. Incorrect TV Format
setting in Analogue TV mode. Set the device to factory
default, then try again.
Possible Causes and Solutions
Picture freezing, and/or
sound distorting
Signal too weak, please check the aerial. Try to use a
proper roof top aerial or an amplified aerial.
No signal
Signal too weak, please check the aerial. Try to use a
proper roof top aerial or an amplified aerial.
Please adjust Brightness and/or Contrast settings.
Dark Picture
Motors/Trains/High Voltage Lines and Neon Lights may
affect the signal.
Snowstorm
Achromatic/Flashing/No Colour
Please adjust the Colour Setting.
Incorrect TV Format setting in Analogue TV mode.
No sound
No image
File Type
Bit Ratio
File Type
Resolution
MP3,WMA
32Kbps~320Kbps
JPG,JPEG(not include non--interlace)
Up to 4000 x 3000 pixels
Music player
Photo viewer
Caption DIVX(4.0, 5.0), XVID
This user manual and instructions are intended for reference purposes only. No further
notice will be given regarding modification of any information contained therein. Due
to continuing improvements, the features and design are subject to change without notice.
Warning
English