Tus neeg siv phau ntawv

ManualsBrandsVirtual Fly ManualsFlight SimulatorVirtual Fly TQ3 Throttle for Flight Simulator

All trademarks and brand names are

trademarks or registered trademarks of their

C. Maria Aurèlia Capmany, 21

P.I. La Fàbrica – 08297 Castellgalí (Spain)

Phone: (+34) 938 333 301

https://www.virtual-ﬂy.com

1. IN THE BOX

A) TQ3/TQ3+

B) Clamp

C) Allen Screws

D) Allen Key

For support, contact us at

support@virtual-ﬂy.com

TQ3 & TQ3+

USER’S MANUAL

Rev 2.2 - April 2022

Summary of content (5 pages)

PAGE 1
A 1x TQ3 & TQ3+ USER’S MANUAL Rev 2.2 - April 2022 1. IN THE BOX A) TQ3/TQ3+ B) Clamp C) Allen Screws D) Allen Key 1x B D C For support, contact us at support@virtual-fly.com 4x © 2022 Virtual Fly, SL All trademarks and brand names are trademarks or registered trademarks of their respective owners. All rights reserved. 1x C. Maria Aurèlia Capmany, 21 P.I. La Fàbrica – 08297 Castellgalí (Spain) Phone: (+34) 938 333 301 https://www.virtual-fly.
PAGE 2
. HARDWARE SETUP 2.1 ATTACHING TO DESKTOP/HOME COCKPIT SETUP You have two options to attach the TQ3/TQ3+ using the included 1 clamp (B) and allen screws (C). For both options, place the TQ3/TQ3+ on the surface it will rest and thighten the knob (a) until you feel strong resistance. OPTION B: Attaching from bottom Make sure to unscrew the two rubber feet before setting up the clamp.
PAGE 3
2.2 CONNECTING TO PC Connect the integrated USB cable from the TQ3/TQ3+ to the computer where the flight simulation software is running. 2.3 ADJUSTING THE LEVER’S HARDNESS b Your TQ3/TQ3+ offers the possibility to adapt the levers’ hardness to your preference. You can do so by rotating the knob (b) as seen in the following diagram. The knob is located on the right side of the TQ3/ TQ3+.
PAGE 4
3. SOFTWARE SETUP The TQ3/TQ3+ interacts with any computer as a joystick (HID), so it is compatible with any flight simulation software. Below, you have 2 options for setting up your TQ3/TQ3+ with the most popular flight simulation software: MSFS, Prepar3D, and X-Plane 11/12. VFHub takes care of making your TQ3/TQ3+ work with MSFS, Prepar3DV4-V5 and X-Plane 11/12, so it must always be running when you use the TQ3/TQ3+. If your device is a TQ3 non-PLUS version, make sure to calibrate the device in VFHub.
PAGE 5
MSFS If you want to customize how your TQ3/TQ3+ works, select the device’s options button ( ) in VFHub’s Dashboard. For detailed instructions on all the tuning and customization possibilities, check the USER’s MANUAL button in the VFHub software. If you own a TQ3 PLUS version, your device is ready to be used in MSFS. If you own a TQ3 non-PLUS version, open MSFS and go to the options menu. Select the controls menu, chose the TQ3 from the device list, and assign the axes as you please.