Product guide

Chapter 6: Diagnostics/Maintenance 6-6
1. Access the CLI through a Telnet session. See Chapter 4: Configuration/Monitoring for more
information.
2. Access the Config-VOIPNetwork-1 prompt.
3. Type setfactory. You will be asked if you are sure you want to set the unit back to factory
defaults.
4. Type yes to confirm (type no to cancel the restore).
Reset System
Reset the system as follows: turn the power switch to “off” and then back to “on”.
Change Password
For security purposes, you may want to change your password. You can change the password via
Command Line Interface (CLI) as follows:
1. Access the CLI through a Telnet session. See Chapter 4: Configuration/Monitoring for more
information.
2. Access the Maintain module.
3. Type password. A prompt will ask you for the old password.
4. Type the old password and press Enter. A prompt will ask you for the new password. Type the
new password and press Enter. A confirmation will ask you to confirm the new password.
5. Re-type the new password and press Enter.
A message will tell you the password that changed successfully.
Change Unit Date and Time
You can change the unit’s date and time via Command Line Interface (CLI) as follows:
1. Access the CLI through a Telnet session. See Chapter 4: Configuration/Monitoring for more
information.
2. Access the Config module.
3. Type date followed by mm/dd/yy/hh:mm:ss and press Enter.
4. For example, type config# date 06/14/02/22:14:00. This command will set the current time to
June 14, 2004 at 10:14 p.m.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]