Product guide

Chapter 3: Installation 3-15
17.For Default Gateway (i.e., 192.168.2.222) choose whether there should be a default gateway
(router) which routes packet data outside of your LAN and enter its IP address.
18.A message will appear on the screen “Tenor BRI Ethernet Interface successfully configured.”
The Tenor will restart using the new Ethernet settings.
Tenor will restart using the new Ethernet settings.
Change IP Address
You are able to change the IP address in which the unit is attached as follows:
NOTE: The instructions below assume you are running Windows 2000 or above.
1. Press the Tenor BX’s power switch to On.
2. Click on Start> Programs> Accessories> Communications>HyperTerminal> Run. The Connec-
tion Description window will be displayed.
3. Enter a connection name (i.e., name for each unit such as Tenor BX New Jersey).
4. Click Ok.
5. Choose the serial port on your PC from the Connect Using drop down list box (i.e., Direct to
Com 1). Click Ok. The Com1 Properties window will be displayed. See Figure 3-10.
Figure 3-10
Port Settings Window
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]