Hardware manual

Boards 2.2
19
Figure 2 View of analog board with all possible states of signalization.
Cross
Green – Physic port with assigned virtual port.
Yellow – Physic port with assigned virtual port and active call (or call establishment).
Earphone
Green – Physic port with assigned virtual port and assigned station.
Yellow – Physic port with assigned virtual port, assigned station and active call (or call
establishment).
Exclamation
Yellow – Physic port without assigned virtual port or physic port without detected state.
Red – Hardware error signalling. For example insufficient signal level for GSM, GSM port without SIM
card, ISDN virtual port with deactivated L1 or L2 (adjustable), ...
Tab Board
Below view of case is displayed tab Board, which is divided into two parts. Upper one shows basic
information about selected board. Meaning of parametres of this section is following:
Position – Number of board position within case as described below.
Type – Type of configured board.
Enabled – With this option you can disable selected board. This function can be used for example for
changing SIM cards without switching off whole PbX.
State – Actual state of the board. Here you can find for example information that configured board
doesn't match to detected.
Detected – In this section you can find detected parameters of the board.
Type – Type of detected board on selected position.
Serial number – Serial number of detected board on selected position.
MAC address – MAC address of detected board on selected position.
Under this part is window with list of ports of selected board. Meaning of particular columns of this list
is explained in the chapter Port list.