User manual
When you bring up ISDN Manager, you can set the appropriate COM port for it to communicate with the
simulator with the settings’ tab (Figure 5). The “gather low-level diagnostics” is used only when working with
the factory.
Figure 5: Setting the COM port for ISDN Manager
Your PC COM port must be congured with the settings in Table 2
Table 2: COM port settings for ISDN Manager
Parameter Value
Baud rate 115200 bps
Data bits 8
Parity None
Stop bits 1
Flow Control Hardware
Once you are in communications with the ISDN simulator, you can click the “About” tab to check rmware and
software versions (Figure 6). See “Upgrading Firmware” for the upgrade procedure, which will give you a
new version of the TMS code. The AVR and Hardware elds in the gure are for factory use.
12
User Manual