User manual
Regulatory Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference in which case the user will be required to correct the interference at
his own expense.
Chapter 2: Introduction
ISDN Simulator is a two port ISDN switch which was designed to ease testing, demonstration and
development of ISDN Basic Rate CPE (TE) equipment. It simulates two ISDN BRI lines reducing installation
and monthly charges from Telephone Company and provides full featured BRI lines for Voice, Data and Video
communications.
ISDN simulator is equipped with “U” (2 wire) and “S/T” (4 wire) interfaces, allowing to connect two devices with
either interface type, including mixed connection between “U” and “S/T” interfaces.
Unpacking
Carefully unpack the items in the shipping box and verify that you have received the following:
1. ISDN Simulator unit
2. Wall mount power adapter
3. ISDN Manager Conguration Diskette
4. DB9F-DB9M 6-ft RS-232 cable for connection to a PC.
Fast Start for Advanced Users
1. Plug the power adapter into a 120 VAC outlet, and connect the DC power cable to the power jack on
your simulator.
2. Make the physical connection(s) between the device(s) for which you want ISDN connections with the
ISDN simulator.
3. Connect the terminal port to a terminal, or a PC with a terminal emulator.
4. Issue commands or use ISDN Manager GUI interface to congure the switch type that you need to
simulate, and any options appropriate for that switch type.
5
User Manual
2 Port ISDN Simulator