User manual
Figure 9: Version information from ISDN Manager “About” tab
On the main screen, you set the “switch-type” (see Table 1).
To set individual port characteristics, click on the appropriate “Port” tab. The screen will then show the current
phone number and, when applicable, SPID settings (see Table 7) for each B channel on the port. You can then
set the values as required.
If you need to congure a B channel in “nailed up”, “semi-permanent”, or “dedicated line” mode, check the
appropriate box at the top of the ISDN Manager screen.
Conguring ISDN Simulator via Terminal Server
Many test environments control all devices from a single point, using a reverse Telnet server to connect to all
devices at a remote site. You can control the ISDN simulator in this manner. You must set the asynchronous
interface on the reverse Telnet server to the values in Table 5, and send the codes in Table 6.
15
User Manual
2 Port ISDN Simulator