User manual

NOTE: System initialization will turn some LEDs ON for a few sec.
1.2.2 Rear Panel Descriptions
1. WAN
The WAN port supports 10/100Base-T networks. This port (built with crossover) allows your voice
gateway to be connected to an Internet Access device, e.g. router, cable modem, ADSL modem, through a
CAT.5 twisted pair Ethernet cable.
2. LAN 1 – LAN 4
The LAN port supports 4 10/100Base-T switch hub networks. These 4 ports allow your PC or Switch/Hub
to be connected to the voice gateway through a CAT.5 twisted pair Ethernet cable.
3. Reset
The reset button, when pressed, resets the cable voice gateway without the need to unplug the power cord.
4. Power
The supplied power adapter connects here. The supplied power adapter converts
110V or 220V AC to DC as required for this device.
5. FXS
These ports connect to your telephone sets or Trunk Line of PBX.
6. FXO
FXO port is connected to the extension port of a PBX or directly connected to a PSTN line.
1.3 Unpacking Your S400 or S200 Series Gateway
Your Gateway package should contain the items listed below. If any item is missing or damaged,
contact your dealer or VoIP Customer Service Department immediately.
• One User manual with warranty/registration card
• One CD-ROM; includes User Manual in electronic form, latest released firmware, and training
material document.
• One AC/AC power adapter (black), AC100-230V, input DC 12/1.5A for Gateway used in US and
Taiwan
1.4 Factory Default Setting
Your N or T Series Gateway package should contain the items listed below. If any item is missing
or damaged, contact your dealer or VoIP Customer Service Department immediately.
z WAN Port IP address : 192.168.1.1
z LAN Port IP address : 10.10.10.1
z LAN DHCP Server enable IP range 10.10.10.51 ~ 10.10.10.100
z VoIP Number port 1 : 100, port 2 :200, port 3 :300, port 4 : 400
z VoIP default setting was H.323 signal protocol, Direct Mode, Fast-Start and G.723 codec.
z Default volume of line and telephone interface was -3 db.
z Default login authentication username : admin, password : admin
1.5 Key Features
The T and N Series Gateways provide many built-in server and software features to provide a
convenient comprehensive solution for your SOHO VoIP network.
VoIP Call :
1. Support G.711/G.723.1/G.729A voice codec.
2. Standard VoIP protocols: H.323, H.225, Q.931, H.245, RTP/RTCP and SIP.
3. Voice: DTMF detection and generation, G.168 compliant echo canceller, silence detection, FAX
(T.38/T.30)Mode Option.
4. Telephony Supplemental services: Inner Conference Call, Speed Dial, Redial, Call Back, Distinct