User manual

Click SNTP Setting to open the Online Status page. In the example,
on the following page,
.
Use SNTP Setting—When checked, Gateway uses a Simple Network Time Protocol (SNTP) to set the date
and time . The Gateway synchronizes the Gateway’s time after you select the time zone. Use SNTP Setting,
Select the time zone which Gateway was at.
Appendix-A FAQ List
1. What is the default administrator password to login to the gateway?
A: By default, your default username is “admin”, default password is “admin” to login to the router.
For
security, you should modify the password to protect your gateway against hacker attacks.
2. I forgot the administrator password. What should I do?
A: Press the Reset button on the rear panel for over 5 seconds to reset all settings to default
values.
3. What is the default IP address of the router?
A: The default WAN IP address is 192.168.1.1 with subnet mask 255.255.255.0.
The default LAN IP address is 10.10.10..1 with subnet mask 255.255.255.0.
4. Why is it that I can ping to outside hosts, but not access Internet
Web sites?
A: Check the DNS server settings on your PC. You should get the DNS servers settings from
your ISP. If your PC is running a DHCP client, remove any DNS IP address setting. As the router
will assign the DNS settings to the DHCP-client-enabled PC.
5. What is the maximum number of IP addresses that the DHCP server of the gateway can
assign to local PCs?
A: The built-in DHCP server can support 253 IP addresses for local