User manual

12: Static routes configuration
_______________________________________________________________________________________________________
Dropbear is the software module that implements ssh on the system. The
dropbear section contains these settings:
Name
Type
Required
Default
Description
enable boolean no 1
Enables dropbear.Set to 0 to
disable starting dropbear at
system boot.
verbose boolean no 0
Enables verbose. Set to 1 to
enable verbose output by the
start script.
BannerFile string no (none)
Specifies the name of a file
to be printed before the user
has authenticated
successfully.
PasswordAuth boolean no 1
Specifies password
authentication. Set to 0 to
disable authenticating with
passwords.
Port integer no 22
Specifies the port number to
listen on.
RootPasswordAuth boolean no 1
Enables root password
authentication. Set to 0 to
disable authenticating as root
with passwords.
RootLogin boolean no 1
Enables root logins. Set to 0
to disable SSH logins as root.
GatewayPorts boolean no (none)
Enables gateway ports. Set
to 1 to allow remote hosts to
connect to forwarded ports.
Interface string no (none)
Tells dropbear to listen only
on the specified interface.
Identity string no
SSH-2.0-
dropbear_2013.60
Sets alternative name that
appears for dropbear version
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 71 of 255