User manual

11: VLAN configuration
_______________________________________________________________________________________________________
11.4.1 config port
Name Type Required Default Description
port Text Yes Blank
Specifies which physical port on
the front panel of the router will be
assigned to which VLAN
trunk Boolean No Blank
Configures the port as a trunk
port.
vlans
Numeric
value/text
Yes Blank
Specifies what VLANs will be
assigned to a physical port on the
router. You must use VLAN ID to
specify which VLANs or ‘all’ to
configure a port as trunk interface.
11.4.2 config vlan
Name Type Required Default Description
vlanid
Numeric
value
No Blank
Defines VLAN number. The VLAN
will be referred to using this
number.
vlanprio
Numeric
value
No Blank
Specifies 802.1p VLAN priority tag
on trunk links.
Isolate Boolean No Blank
Defines whether to isolate hosts
from each other within the same
VLAN. Hosts will still be able to
communicate with the router.
name Text Yes Blank Configures VLAN name.
ipaddr
IP
Address
Yes Blank
Configures network mask address
to be used on this VLAN.
netmask
IP
Address
Yes Blank
Configures network mask address
to be used on this VLAN.
11.4.3 Config nat vlan
Name
Type
Required
Default
Description
Nat vlanid
Numeric
value
No Blank
VLAN ID number. Defines VLAN
that will be sent across the trunk
untag
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 68 of 255