User manual

11: VLAN configuration

_______________________________________________________________________________________________________

root@VA_router:~# uci show portvlan

portvlan.@vlan[0]=vlan

portvlan.@vlan[0].vlanid=1

portvlan.@vlan[0].name=vlan1

portvlan.@vlan[0].ipaddr=192.168.1.1

portvlan.@vlan[0].netmask=255.255.255.0

portvlan.@vlan[0].isolate=no

portvlan.@vlan[1]=vlan

portvlan.@vlan[1].vlanid=2

portvlan.@vlan[1].name=vlan2

portvlan.@vlan[1].ipaddr=192.168.2.1

portvlan.@vlan[1].netmask=255.255.255.0

portvlan.@vlan[1].vlanprio=5

portvlan.@vlan[1].isolate=yes

portvlan.@port[0]=port

portvlan.@port[0].port=A

portvlan.@port[0].vlans=1

portvlan.@port[1]=port

portvlan.@port[1].port=B

portvlan.@port[1].vlans=2

portvlan.@port[2].port=C

portvlan.@port[2].trunk=yes

portvlan.@port[2].vlans=all

portvlan.nat_vlan=nat_vlan

portvlan.nat_vlan.nat_vlanid=1

Modify these settings by running uci set <parameter> command.

The following tables describe the UCI parameters for each section.

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 67 of 255