User manual

11: VLAN configuration
_______________________________________________________________________________________________________
11 VLAN configuration
11.1 VLAN web interface
You can configure VLANs through three sections:
• Native VLAN
• VLAN Definition
• Port Description
• Native VLAN
Figure 11: The native VLAN section
The Native VLAN section specifies the native VLAN to be used. This VLAN will be
sent untagged across the trunk link.
Note: you must create the VLAN before setting it as native.
Name Type Required Default Description
802.1Q VLAN ID
Numeric
value
No Blank
VLAN ID number defines VLAN
that will be sent across the trunk
untagged. NO 802.IQ tag will be
applied to the packets on that
VLAN.
Table 10: Native VLAN field name and description
11.2 VLAN definition
Use the VLAN definition section to define VLANs and assign them with VLAN ID,
name and required network configurations.
Figure 12: The VLAN definition section
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 64 of 255