User manual

9: Management configuration settings
_______________________________________________________________________________________________________
conloglevel and will
override it.
log_file string no /var/log/messages
Defines which file to write
log messages to (type file).
log_ip
IP
address
no (none)
Specifies IP address of a
syslog server to which the
log messages should be
sent in addition to the local
destination.
log_port integer no 514
Specifies port number of
the remote syslog server
specified with log_ip.
log_size integer no 16
Sets size of the file or
circular memory buffer in
KiB.
log_type string no circular
Specifies either a circular
or file log type.
timezone string no UTC
Specifies the time zone
that date and time should
be rendered in by default.
time_save_interval_min integer no 10
Stores local time every N
minutes so it will be used
on the next boot.
The table below describes the fields in the Time Synchronization section.
Name Type Required Default Description
Enable
builtin
NTP
server
Boolean No 0 Enables NTP server
NTP
update
interval
Dropdown
menu
No 2 Specifies interval of NTP requests
server
list of
hostnames
no (none)
Defines the pool of NTP servers to poll the
time from. If the list is empty, the built in
NTP daemon is not started.
A sample system configuration is shown below.
root@VA_router:~# uci show system
system.main=system
system.main.hostname=VA_router
system.main.timezone=UTC
system.main.log_ip=10.1.83.36
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 47 of 255