User manual

9: Management configuration settings

_______________________________________________________________________________________________________

package httpclient

config core 'default'

option Enabled 'yes'

list FileServer '10.1.83.36:80'

list FileServer '10.1.83.37:80'

list SecureFileServer '10.1.83.36:443'

list SecureFileServer '10.1.83.37:443'

option ActivatorDownloadPath

'/Activator/Sessionless/Httpserver.asp'

option SecureDownload 'no'

option PresentCertificateEnabled 'no'

option ValidateServerCertificateEnabled 'no'

option CertificateFile '/etc/httpclient.crt'

option CertificateFormat 'PEM'

option CertificateKey '/etc/httpclient.key'

This sample contains the settings to enable the device to report its status to

Monitor. To allow Monitor to track the IP address and ongoing presence of the

device, a heartbeat SNMP trap is sent by default every minute.

Use the following settings to configure this feature.

Name Type Required Default Description

Enable boolean yes no Enables Monitor to send heartbeats.

interval_min boolean No 1

Specifies the interval at which traps are

sent.

dev_reference String yes (none)

Sets a unique identification for this

device known to monitor.

monitor_ip string yes (none)

Defines the IP address of Monitor. It is

possible to specify multiple addresses to

which SNMP heartbeat traps will be sent.

A sample Monitor configuration is shown below.

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 44 of 255