User manual

31: Diagnostics
_______________________________________________________________________________________________________
tserv show userial stats - show USB serial card statistics
tserv clear userial stats - clear USB serial card statistics
tserv start userial rxlog <Port> - start USB serial card rx log
tserv show userial rxlog <Port> <offs> <length> - show USB serial card rx
log
tserv show userial version <Port> - show USB serial card firmware version
tserv show userial cpld status <Port> - show USB serial card CPLD
programming status
tserv upgrade userial - initiate upgrade of the USB serial card
tserv quit - terminate termserv process
Note: tservd process has to be running otherwise diagnostics options for
terminal server will not be available.
31.16 VRRP diagnostics
Two available diagnostic options exist: via web interface and command line.
31.16.1 VRRP diagnostics web interface
To see VRRP through the web interface, in the top menu, select Status ->
Status. The VRRP status settings appear.
Figure 117: The VRRP status settings
31.16.2 VRRP diagnostics using the command line interface
To view VRRP using the CLI interface, SSH into the router and enter:
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 254 of 255