User manual

31: Diagnostics
_______________________________________________________________________________________________________
option priority '2'
option manage_state 'yes'
option exclusive_group '0'
option ifup_retry_sec '300'
option ifup_timeout_sec '40'
The following output shows the multi-WAN standard stop/start commands for
troubleshooting.
root@VA_router:~# /etc/init.d/multiwan
Syntax: /etc/init.d/multiwan [command]
Available commands:
start Start the service
stop Stop the service
restart Restart the service
reload Reload configuration files (or restart if that fails)
enable Enable service autostart
disable Disable service autostart
When troubleshooting, make sure that the routing table is correct using
route –n.
Ensure all parameters in the multi-WAN package are correct. The name used for
multi-WAN must be identical, including upper and lowercases, to the actual ADSL
interface name defined in your network configuration.
To check the names and settings are correct, browse to Network - >
interfaces or alternatively, run: cat/etc/config/network through CLI.
Enter the name of the WAN interface to configure, and then click Add. The new
section for configuring specific parameters will appear.
31.14 PAD diagnostics
31.14.1 Showing Log
The modules will write events to the log if they are configured to do so.
To see the event that are already logged, type the following at the command
prompt: logread.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 251 of 255