User manual

31: Diagnostics

_______________________________________________________________________________________________________

root@VA_router:~# FW_TRACE=1 fw reload 2>/tmp/iptables.log

31.9 GPS diagnostic commands

You can use the utility GPS to run diagnostic commands against the GPSD

application.

When you run GPS at the command prompt without parameters, it prints the

menu listing all available commands.

For example to view the last known router position, enter gpspeek:

root@Demo:~# gpspeek

Fix: 3D,1423135517,53.342546,-6.241331,23.800000,223.700000,0.000000,nan

31.10 Interfaces diagnostics

31.10.1 Interfaces status

To show the current running interfaces, enter:

root@VA_router:~# ifconfig

3g-CDMA Link encap:Point-to-Point Protocol

inet addr:10.33.152.100 P-t-P:178.72.0.237 Mask:255.255.255.255

UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1400 Metric:1

RX packets:6 errors:0 dropped:0 overruns:0 frame:0

TX packets:23 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:3

RX bytes:428 (428.0 B) TX bytes:2986 (2.9 KiB)

eth0 Link encap:Ethernet HWaddr 00:E0:C8:12:12:15

inet addr:192.168.100.1 Bcast:192.168.100.255

Mask:255.255.255.0

inet6 addr: fe80::2e0:c8ff:fe12:1215/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:6645 errors:0 dropped:0 overruns:0 frame:0

TX packets:523 errors:0 dropped:0 overruns:0 carrier:0

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 244 of 255