User manual

31: Diagnostics
_______________________________________________________________________________________________________
root@VA_router:~# cesop clear stats
cesopd stats cleared.
31.6 DMVPN diagnostics
In the top menu, click Status -> IPSec. The IPSec Connections page appears.
Figure 115: The IPSec connections page
In the Name column, the syntax contains the IPSec Name defined in package
dmvpn and the remote IP address of the hub, or the spoke separated by an
underscore; for example, dmvpn_213.233.148.2.
To check the status of DMVPN, in the top menu, click Status -> DMVPN.
Figure 116: The NBMA peers page
NBMA Address Interface Address Type
Public IP address of
the peer.
Interface name Tunnel IP address of
remote node.
Spoke is presented if it
is reachable. Hub is
known regardless of
its reachability. There
are two hub statuses
‘hub’ and ‘dead hub’.
Table 37: NBMA peers columns and their descriptions
You can check IPSec status using uci commands.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 237 of 255