User manual

31: Diagnostics
_______________________________________________________________________________________________________
schedule_priority : 10
Port 1 config
--------------------
cardType : Single AAL card
enable : 1
clock_recovery_enabled : 1
clock_recovery_debug : 0
remote_loopback : 0
udp_local_ipaddr : 0.0.0.0
udp_local_port : 5152
udp_remote_ipaddr : 10.1.42.63
udp_remote_port : 5152
rtp_payload_type : 96
packetization_latency : 5
rx_jitter_buffer_enabled : 0
rx_jitter_buffer_size_ms : 24
app_bit_reverse : 0
app_rx_shift : 0
devname : ttyLC0
bypass : 0
local_loopback : 0
dce : 1
rate : 64000
ext_clock : 0
fifo_irq_level : 1
bit_reverse : 0
dte_tt_inv : 0
dce_tclk_inv : 0
dce_rclk_inv : 0
x21_clk_invert : 0
x21_data_delay : 0
x21_use_vco : 0
all_four_wire_mode : 0
all_pcm_encoding : alaw
all_rx_attenuator_enabled : 1
all_rx_analogue_gain_enabled : 0
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 234 of 255