User manual

31: Diagnostics
_______________________________________________________________________________________________________
You can set the statistical information using ‘va5420_stats_reset
/dev/ttyLC0’.
The example below shows the command ‘va5420_status /dev/ttyLC0’; it
displays status information about the device.
root@VA_router:~# va5420_status /dev/ttyLC0
Mode: Transparent
Wire mode: 2-wire
PCM Encoding: A-Law
31.3 Automatic operator selection diagnostics via the web interface
31.3.1 Checking the status of the Multi-WAN package
When interfaces are auto created they are presented in the network and in the
Multi-WAN package.
To check interfaces created in the Multi-WAN package, from the top menu, select
Network -> Multi-WAN.
To check interfaces that have been created in the network package, from the top
menu, select Network -> Interfaces.
Figure 111: The interface overview page
To check the status of the interface you are currently using, in the top menu,
click Status. The Interface Status page appears.
Scroll down to the bottom of the page to view Multi-WAN Stats.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 230 of 255