User manual

7:File system
_______________________________________________________________________________________________________
7 File system
7.1 Configurations
Configurations are stored in folders at:
/etc/conf/factconf,
/etc/conf/config1
and
/etc/conf/config2
Multiple configuration files exist in each folder. Each file contains configuration
parameters for different areas of functionality in the system.
A symbolic link exists at:
/etc/conf/config, which always points to one of factconf, config1 or config2.
Files that appear to be in /etc/conf/config are actually in
/etc/conf/factconf|config1|config2 depending on which configuration is
active.
If /etc/conf is missing on start-up, for example on first boot, the links and
directories are created with configuration files copied from
/overlay/etc/config/.
At any given time, only one of the configurations is the active configuration.
To show the active configuration file, enter:
root@VA_router:~# vacmd show current config
To set the boot configuration to run on next reboot, enter:
root@VA_router:~# vacmd set next config [factconf|config1|config2]
7.1.1 High level configuration commands
To show the configuration currently running, enter:
root@VA_router:~# vacmd show current config
To show the configuration to run after the next reboot, enter:
root@VA_router:~# vacmd show next config
To set the configuration to run after the next reboot, enter:
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 22 of 255