User manual

29: Configuring SLA reporting on Monitor

_______________________________________________________________________________________________________

29 Configuring SLA reporting on Monitor

29.1 Introduction

This section describes how to configure and view SLA reporting on Monitor, the

Virtual Access monitoring system. It also explains how to configure scheduler

task that is placed on the router to upload SLA statistics.

The Virtual Access Monitor system provides:

• centralised access to router connectivity status,

• access to advanced router diagnostic tools, and

• access to SLA Report Management.

The SLA Report Manager can build reports from a list of selected routers

presenting a range of statistics over extended periods of time, including:

• Availability

• Latency

• Packet loss

• 3G signal strength

29.2 Configuring SLA reporting

To configure SLA reporting on Monitor, you must first add a content template

and then build an SLA report based on it. A content template allows you to

enable and configure report elements that you can then add to an SLA report.

When you have added a content template, you can then add an SLA report.

29.2.1 Configuring a content template

Click Settings on the Monitor home page. The settings page appears.

Figure 89: The settings page on Monitor

In the top menu, select SLA Reporting ->Content Templates. Then click

Create. The Add/Edit Content Template page appears.

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 214 of 255