User manual

28: Event system
_______________________________________________________________________________________________________
subject_template String No None
Template to use for the email
subject
body_template String No None Template to use for the email body
conn_tester String No None
Name of the connection tester to
use for this target
Table 32: Event system – email target settings description
28.6.4.3 SNMP target
When a SNMP target receives an event, it sends it in a trap to the configured
SNMP manager.
config target
option name snmp
option enabled yes
option type snmptrap
option community public
option target_addr 192.168.0.1
option agent_addr 192.168.0.4
option conn_tester pinger
The table below describes SNMP target parameters.
Name Type Required Default Description
name String Yes None
Name of the target to be used in
the forwarding section
enabled Boolean Yes Yes Enable this target
type String Yes snmptrap
Must be snmptrap for a snmp
target
Community String Yes None
Community name to use to send
the trap
target_addr
IP Address
Yes
None
IP Address of a the SNMP Manager
agent_addr IP Address No None
IP Address to use as the trap
source IP address
conn_tester String No None
Name of the connection tester to
use for this target
Table 33: Event system – snmp target settings description
28.6.4.4 Exec target
When an exec target receives an event, it executes a shell command.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 207 of 255