User manual

28: Event system
_______________________________________________________________________________________________________
The table below describes link connection tester parameters.
Name Type Required Default Description
name String Yes None
Name of the target to be used in
the target section
enabled Boolean Yes Yes Enable this connection tester
type String Yes Link
Must be link for a link connection
tester
link_iface String Yes None Interface name to check
Table 30: Event system – link connection tester settings description
28.6.4 Supported targets
There are four possible targets.
• Syslog target
• Email target
• SNMP target
• Exec target
28.6.4.1 Syslog target
When a syslog target receives an event, it sends it to the configured syslog
server.
config target
option name syslog1
option enabled yes
option type syslog
option target_addr "192.168.0.1:514"
option conn_tester t1
The table below describes syslog target parameters.
Name Type Required Default Description
name String Yes None
Name of the target to be used in
the forwarding section
enabled
Boolean
Yes
Yes
Enable this target
type String Yes Syslog Must be syslog for a syslog target
target_addr
IP
Address:Port
Yes None
IP Address and Port number to
send the syslog message to. If no
port is given, 514 is assumed
conn_tester String No None
Name of the connection tester to
use for this target
Table 31: Event system – syslog target settings description
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 205 of 255