User manual

28: Event system
_______________________________________________________________________________________________________
SNMP Event sent via SNMP trap
Exec Command executed when event occurs
Table 25: Event system - supported targets
The attributes of a target vary significantly depending on its type.
28.4 Supported connection testers
The table below describes the methods to test a connection that are currently
supported:
Type Description
link Checks if the interface used to reach the target is up
ping
Pings the target.
It then assumes there is connectivity during a configurable amount of time
Table 26: Event system - supported connection tester methods
28.5 Configuring the event system via the web interface
Configuring the event system via the web interface is not currently supported.
28.6 Configuring the event system via UCI
The event system configuration files are stored on:
/etc/config/va_eventd
The configuration is composed of a main section and as many forwardings,
targets and connection testers as required.
28.6.1 Main section
config va_eventd main
option enabled yes
option event_queue_file '/tmp/event_buffer'
option event_queue_size 128K
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 202 of 255