User manual

26: Terminal Server

_______________________________________________________________________________________________________

# bit reverse: 0=normal; 1=reverse

option bit_reverse 0

# v24 dte tt clock invert: 0=normal; 1=invert

option dte_tt_inv 0

# v24 dce tx clock invert: 0=normal; 1=invert

option dce_tclk_inv 0

# v24 dce rx clock invert: 0=normal; 1=invert

option dce_rclk_inv 0

# x21 clock invert: 0=normal; 1=invert

option x21_clk_invert 0

# x21 data delay: 0-7 - delay in local clk or VCO clock cycles

option x21_data_delay 0

# destination peer ip address (two addresses for failover)

option remote_ip1 '10.1.10.211'

option remote_ip2 '0.0.0.0'

# keep TCP session always connected

option tcp_always_on 0

# close TCP session on detection of DSR signal low

option close_tcp_on_dsr 1

# Forwarding timeout in milliseconds (serial to network)

option fwd_timeout 30

# Forwarding buffer size (serial to network)

option fwd_buffer_size 256

# Receive control characters that cause buffer to be forwarded

option rcc_string ''

# serial device speed in baud

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 192 of 255