User manual

26: Terminal Server

_______________________________________________________________________________________________________

# when used with V.23 modem driver, (set portmode 'v23') LIM operation:

0=2wire; 1=4wire

option v23_is_four_wire '0'

# when used with V.23 modem driver, (set portmode 'v23'), sets the

receive echo suppression timeout in milliseconds

option v23_tx_timeout '20'

# when used with V.23 modem driver, (set portmode 'v23'), time in

milliseconds it takes V.23 transmitter to rampdown carrier from peak to

zero

option v23_tx_rampdown '30'

# when used with V.23 modem driver, (set portmode 'v23'), sets the

maximum transmit fifo fill level in bytes

option v23_tx_maxfill '127'

# when used with V.23 modem driver, (set portmode 'v23'), enables

signalling of carrier by sending special characters

option v23_inband_carrier_signalling '0'

# when used with V.23 modem driver, (set portmode 'v23'), this

character decimal value signalls remote carrier on

option v23_inband_carrier_on_char '255'

# enables HDLC Pseudowire over UDP support (based on RFC4618), if set

to 1, also set udpMode 1

option hdlc_pw_enabled 0

# Configures serial transmit log size in bytes and enables transmit

data logging. 0=disabled

option serialTxLogSize 0

# Configures serial receive log size in bytes and enables receive data

logging. 0=disabled

option serialRxLogSize 0

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 191 of 255