User manual

26: Terminal Server

_______________________________________________________________________________________________________

option is_usb_serial 0

# Used for USB serial card. 'hdlc' = synchronous HDLC framed mode;

'transp' = transparent mode

option sync_mode 'hdlc'

# Used for USB serial card. 1= in HDLC mode use CRC32; 0= use CRC16

option sync_crc32 0

# Used for USB serial card. Synchronous speed, If not 0, use internal

clock, example speeds: 9600, 19200, 64000, 128000, 256000, 384000, 512000,

768000, 1024000, 2048000, 0=use external clock

option sync_speed '64000'

# Used for USB serial card. Enables receive clock inversion. 0=data

sampled on clock falling edge; 1=data sampled on clock rising edge

option sync_invert_rxclk 0

# Used for USB serial card. Enables transmit clock inversion. 0=data

out on clock falling edge; 1=data out on clock rising edge

option sync_invert_txclk 0

# Used for USB serial card. 1=receive most significant bit first;

0=receive least significant bit first

option sync_rx_msbf 0

# Used for USB serial card. 1=transmit most significant bit first;

0=transmit least significant bit first

option sync_tx_msbf 0

# Used for USB serial card. Number of bit positions to delay sampling

the data from detecting clock edge

option sync_rxdata_dly 0

# Used for USB serial card. Number of bit positions to delay output of

the data from detecting clock edge

option sync_txdata_dly 0

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 189 of 255