User manual

26: Terminal Server
_______________________________________________________________________________________________________
0=normal operation.
TCP always on Checkbox No Disabled Keep TCP session always connected.
Close TCP on DSR Checkbox No Disabled
Close TCP session on detection of
DSR signal low.
Reconnect time
(ms)
Numeric
value
No 5000
Time in milliseconds to start re-
connecting after setting DTR low.
Table 24: The Network fields descriptions
26.4 Configuring Terminal Server using UCI
You can also configure Terminal Server through CLI using UCI command suite.
The configuration file is stored at:
/etc/config/tservd
To view the configuration file, use commands:
uci export
or
uci show
The global configuration section contains two parameters. The meaning of the
parameters is explained in the embedded comments:
config tservd main
# set to 1 to enable Terminal Server
option enable 1
# enables detailed debug logging (state transitions, data transfer etc)
option debug_ev_enable 1
Following the global section there are four port specific sections. Below is an
example configuration with the embedded comments explaining each parameter.
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 184 of 255