User manual

26: Terminal Server
_______________________________________________________________________________________________________
Figure 871: The Network tab fields part 2
Name Type Required Default Description
Transport mode
Dropdown
list
Yes TCP Select between TCP/UDP.
Local IP
IP
address
Yes 0.0.0.0
Local IP address to listen on
(0.0.0.0=listen on any interface).
TCP mode
Dropdown
list
Yes Server
Select between server and client
modes of TCP.
TCP listen port
Numeric
value
Yes 999 TCP listen port for server mode.
Remote IP 1
IP
address
Yes 0.0.0.0 Destination peer IP 1address
Remote IP 2
IP
address
Yes 0.0.0.0
Destination peer IP 2 address(for
failover).
Remote TCP Port 1
Numeric
value
Yes 951 Destination peer port IP 1 number.
Remote TCP Port 2
Numeric
value
Yes 951
Destination peer port IP 2
number(for failover).
Enable TCP
keepalives
Checkbox No Enabled Enable or disable TCP keep alives.
TCP Keepalive
interval
Numeric
value
No 5
Interval in seconds between TCP
keep alive probes.
TCP Keepalive
timeout
Numeric
value
No 2
Time in seconds to wait for reponse
to a TCP keep alive probe.
TCP Keepalive
count
Numeric
value
No 1
Number of TCP keep alive probes to
send before connection closed.
TCP User timeout
Numeric
value
No 0
Maximum time in milliseconds for
TCP to wait for transmitted data to
be acked before closing connection
in established state. Set to 0 to use
kernel defaults (about 15-20
minutes).
TCP nodelay Checkbox No Disabled 1=disable TCP nagle algorithm;
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 183 of 255