User manual

25: Dynamic Multipoint Virtual Private Network (DMVPN)
_______________________________________________________________________________________________________
Figure 80: The DMVPN general section
Check Enable DMVPN.
From the IPSec template connection drop down menu, provide the name of the
IPsec connection.
In the DMVPN Hub Settings section, click Add. The fields required to configure
the parameters relative to the DMVPN Hub appear. These are used for the
DMVPN tunnels, such as GRE tunnels, GRE tunnel remote IP, DMVPN Hub IP and
password.
Name Type Required Default Description
GRE Interface
Dropdown
list
Yes Blank
Specifies which GRE interface will
be used with this DMVPN
configuration.
GRE Remote
Endpoint IP
Address
IP
address
Yes Blank
Configures the GRE IP address of
the hub.
DMVPN Hub IP
Address
IP
address
Yes Blank
Configures the physical IP address
for the DMVPN hub.
NHRP
Authentication
Numeric
value
Yes Blank
Enables authentication on NHRP.
The password will be applied in
plaintext to the outgoing NHRP
packets. Maximum length is 8
characters.
NHRP Holding
Time
Integer Yes Blank
Timeout for cached NHRP
requests.
Table 21: DMVPN hub fields and their descriptions
25.5 UCI interface
25.5.1 IPSec configuration using CLI
You can configure IPSec (strongSwan package) through CLI using the UCI
command suite.
Configuration files are stored at:
_______________________________________________________________________________________________________
© Virtual Access 2015
GW1000 Series User Manual
Issue: 2.4 Page 173 of 255