User manual

4: Factory configuration extraction from SIM card

_______________________________________________________________________________________________________

4 Factory configuration extraction from SIM card

Virtual Access routers have a feature to update the factory configuration from a

SIM card. This allows you to change the factory configuration of a router when

installing the SIM.

6. Make sure the SIM card you are inserting has the required configuration written on it.

7. Ensure the router is powered off.

8. Hold the SIM 1 card with the chip side facing down and the cut corner front left.

9. Gently push the SIM card into SIM slot 1 until it clicks in.

10. Power up the router.

Depending on the model, the power LED and/or the configuration LED flash as

usual.

The SIM LED starts flashing. This indicates the application responsible for 3G and

configuration extraction management is running. It also means the update of the

configuration is happening.

When the update is finished, depending on the model, the power LED and/or the

configuration LED blink alternatively and very fast for 20 seconds.

_______________________________________________________________________________________________________

GW1000 Series User Manual

Issue: 2.4 Page 17 of 255